Find the user manual and the help you need for the products you own at ManualsOnline. I got an old laptop model MA2 without powersupply. SetIP command to see and change the IP addresses of the console. This command can be used to change both Ethernet connectors and even set a gateway. Requirement: STP (shielded twisted pair) cable with RJ45 connector, min. Cat 5e . To connect Ethernet port 1: Connect one end of an Ethernet cable to the.

Author: Mikagore Zumi
Country: Puerto Rico
Language: English (Spanish)
Genre: Medical
Published (Last): 25 August 2004
Pages: 332
PDF File Size: 10.48 Mb
ePub File Size: 8.95 Mb
ISBN: 342-7-44693-484-5
Downloads: 15043
Price: Free* [*Free Regsitration Required]
Uploader: Dougrel

An IP address in a matching range is needed to be able to connect devices. Thank you for the advice. I think my problem gatweay the number IV. I have since opted from step by step details due to the number of questions from non-techs.

Gateway Laptop MA2 User’s manual |

You may want to view the latest help version. It took a dozen wires to equal the diameter of a human hair. I did gatewwy you suggested and jumpered from the POS to the diode leg. Windows states the charger is plugged in and charging but the battery consistently drains.


Connect Ethernet

I was hopeing you have some info for me on a similar symptom on a dell d The motherboard is slightly different than the MA7 you describe here. Older posts are rarely answered and the information is in pictures here showing the failure point. Hoosier Newman Wed May 22, The substrate was about the size of an pencil eraser, and from there we had to add a custom chip, SMT caps, resistors and 12 gold filament wires.

Chance Sat Aug 14, I grabbed another power cord working just fine.

The only way it works now is if a external monitor is plugged in. Manaul going to jump the pin, but you are not specific in the detail. Not Stupid Ken, You solved it.

Thanks for the info! Only a member of this blog may post a comment.

If you are unfamiliar with the components, you may need to contact a technician. Maybe mmanual missing capacitor s took out part of the charging circuit? Anonymous Sat Aug 07, I tried it first on a salvage DV board set up in a similar way and it burned up some fets.


I’m trying to picture this in my mind. I get 19v to the diode.

Then it is usually the AO Mosfet. All I see left on the chip is 04, the rest is blown. Usually broken inside the back manuual the elbow bend. Thanks – thanks and thanks – I am more versed in programming than hardware these days, but I do have excellent soldering skills and I thought this was an easy fix But in all respect it might be time to decide to get a newer or new used laptop that has either Vista or Windows7 that support the DDR2 or DDR3 in some so you can spend less on those Ram.

Check with meter in Diode or Resistance. Mayo Hardware Sat Jul 24, In some cases the CMOS is totally corrupt and needs to be replaced. Where should I solder to on the ma3? Just read through all of these comments.